Kumštelinio velenėlio pertvarkymas 37n | ANDREWS
Specifikacijos
| Gamintojas | ANDREWS |
|---|---|
| Prekės kodas | 216837 |
| Įsiurbimo pakėlimas prie tdc imperial | 0.174" |
| Išmetimo sistemos atviras imperial | 46° |
| Išmetimo trukmė | 236° |
| Išmetimo sistemos keltuvas | 0,510" |
| Įsiurbimo trukmė | 240° |
| Įsiurbimo liftas | 0,510" |
| Paraiška | Exhaust| Intake |
| Išmetimo sistemos uždarymas | 14° |
| Išmetimo anga atidaryta | 46° |
| Įsiurbimo uždarymas | 48° |
| Įsiurbimo anga atidaryta | 18° |
| Funkcijos | Can Be Used with Stock Springs and Tappets |
| Tipas | Chain |
| Vienetai | Pair |
| Išmetimo kėlimas prie tdc | 0,148" |
| Šlifavimas | 37 Series |
| Išmetimo lęšio vidurio linija | 106° |
| Įsiurbimo sklendės vidurio linija | 100° |
| Įsiurbimo pakėlimas prie tdc | 0,174" |
| Išmetimo sistemos keltuvas imperial | 0.510" |
| Išmetimo sistemos pakilimas prie tdc imperial | 0.148" |
| Įsiurbimo trukmė imperial | 240° |
| Įsiurbimo sistema open imperial | 18° |
| Įsiurbimo uždarymas imperial | 48° |
| Įsiurbimo kėliklis imperial | 0.510" |
| Išmetimo trukmė imperial | 236° |
| Išmetimo sistemos uždarymas imperial | 14° |
| Išmetimo lęšio vidurio linija imperial | 106° |
| Įsiurbimo sklendės vidurio linija imperial | 100° |
Produkto aprašymas
Allow you to upgrade your 99-06 Twin Cam (except 06 Dyna Glide) to the newer roller-style cam chains and replaces the spring tension cam chain adjusters with the later-style hydraulic adjusters for longer life Cam grinds listed are designed to be used with stock lifters; they require the installation of a 07-17 cam plate, oil pump, cam sprockets and chains, and both hydraulic chain adjusters (these parts are not included and must be purchased separately) A list of required components is supplied with each set of cams Performance should be similar to earlier bikes with the same cam grinds Made in the U.S.A. 99-06 Twin Cam motors (except 06 Dyna Glide) cannot use the 07-17 cams, as the bearing journal on the earlier motors is .875" in diameter and the 07-17 cams are 1.000" in diameter. The "N" series of cams feature the .875" bearing journal, yet still accept the new style cam support plate 99-01 model motors must use the Andrews rear cam sprocket Drag part #0925-0147. 2002-2006 models must use the stock rear cam sprocket, OEM #25728-06 Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance
Bolt-in cams for 88" or 95" motors
Smooth idle, broad torque band
Run best with low-restriction